Chrysanthemum drying room is mainly used for drying machines. Also called air dryer is through heat pump, will be placed in the relatively closed insulation board room, through closed dry air circulation to condense water vapor on the cold sheet and discharge the board room, to achieve the intention of dehumidification and boring.
Drying room
Drying room working principle:
(1) Compression process:
Low temperature and low pressure refrigerant gas is compressed into high temperature and high pressure gas by the compressor. At this moment, the work done by the compressor is converted into the internal energy of the refrigerant gas, which increases the temperature and pressure, and is called an adiabatic process in thermodynamics.
(2) Condensation process:
The high temperature and high pressure refrigerant gas from the compressor flows through the condenser. It uses the wind or water to continuously release heat to the outside world. Condenses into medium temperature and high pressure refrigerant liquid. When the refrigerant is liquefied, the temperature drops but the pressure remains the same, which is called isobaric process in thermodynamics.
(3) Saving process:
The medium temperature and high pressure refrigerant liquid from the condenser becomes low temperature and low pressure refrigerant liquid by saving the equipment. In thermodynamics, it’s called an isenthalpy process.
(4) Evaporation process:
The low temperature and low pressure refrigerant liquid from the saving equipment flows through the evaporator. Uses wind or water to continuously absorb heat indoors, and evaporates into low temperature and low pressure refrigerant gas. The absorbed heat becomes the latent heat of the refrigerant, and although the temperature increase is not large, the internal energy increase is large. Because the pressure does not change much, it is called isobaric process in thermodynamics.
Drying room skills characteristics:
1. Only water is discharged from the boring process. Almost no energy loss, energy is completely recovered, so the power is very high, which is several times of the traditional open-loop boring method;
2. Power has nothing to do with the outside temperature and humidity, all the year round, any dry climate effect is common;
3. Outside dust can not enter, safety and health, to meet the health needs of all kinds of goods;
4. Because the dry process is closed loop and low temperature dry, so it will not destroy the dry goods, to ensure the quality and quality of the goods.
5. Selection of dehydration dry, so dry board room will not steam, reduce the dry process of fine bacteria breeding
6. Because of the closed-loop method, it can pass the strong wind convection (traditional open loop is difficult to use the strong wind convection), there is no dead Angle, uniform common;
7. Choose different suspension placement methods, to be strong wind convection, so the boring process without turning, save labor costs;
8. Capable of single/networking/network connection compatible planning, full computer control, can be achieved by computer or mobile phone long-distance monitoring;
9. The board room and the shelf are simple and sensitive, and the amount of boring can be used by any number of hosts side by side, which can be planned into the board room type or assembly line type.
